![]() The idea behind this is anything (a device, another switch with lots of devices, etc) plugged into ports of your choosing will inherit the isolated VLAN membership you create. Scroll to the bottom and save, router will reboot again.Uncheck/remove any port(s) you want as members from VLAN 1.Don’t touch VLAN1 or VLAN 2 with the WAN bridge. Now you’re ready to create your new VLAN, this will be associated with the br1 bridge (or whatever you created above) for either a physical wired port on your router or a new virtual wireless network. NOTE: DO NOT use 10.0.0.1/24, for some reason (bug?) this range will not work even though it’s a valid RFC1918 address range.Īfter your router reboots you can check the bridge was created successfully, it will be in the MOTD when you SSH into the router and the ip a command should also show it. Scroll to the bottom and save, router will reboot.Enter an RFC1918 private address range (e.g.Navigate to Basic –> LAN and create a new bridge.For this I used br1 but you can use whatever you like. The first thing you’ll need to do is create a new bridge interface, this allows you to associate a new VLAN with a physical port (and later associate a virtual wireless SSID if needed). I’m still using the Tomato setup here however so check that guide out after you’ve got this how you like it. Update: : I am now using Pi-Hole and a Raspberry Pi2 to handle DNS for further privacy, filtering and to ward off advertisements and trackers. Tomato shibby webmon verification#
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |